Whirlpool AccuBake Oven Self Cleaning Manual

The Whirlpool AccuBake Oven features an advanced self-cleaning system that uses high heat to burn off food residue and spills, leaving only a small amount of ash that can be easily wiped away. This manual covers safety precautions, operating instructions, cleaning procedures, and troubleshooting for the self-cleaning function. Below are key sections for proper use and maintenance of your AccuBake oven's self-cleaning feature.

1. Safety Precautions 2. Preparing for Self-Cleaning 3. Self-Cleaning Operation 4. Post-Cleaning Procedures 5. Control Panel Features 6. Manual Cleaning Options 7. Troubleshooting 8. Maintenance Tips 9. Specifications 10. Warranty Information

Safety Precautions

Important safety information for using the self-cleaning function.

Precaution	Description
Ventilation	Ensure kitchen is well-ventilated during cleaning cycle
Remove items	Take out all oven racks, pans, and accessories
Child safety	Keep children away from oven during cleaning
Smoke alarms	Temporarily disable nearby smoke detectors if necessary
Pets	Remove pets from kitchen area during cleaning
Door lock	Do not attempt to open door during cleaning cycle
Temperature	Exterior surfaces become very hot - avoid contact
Timer	Never leave home during self-cleaning operation

Preparing for Self-Cleaning

Proper preparation ensures effective and safe cleaning.

Remove all oven racks, pans, and baking stones from oven cavity.
Wipe up large food spills and excess grease with damp cloth.
Clean oven door gasket to ensure proper seal.
Ensure oven door closes completely and locks properly.
Remove any combustible materials from near the oven.

WARNING! Do not use oven cleaners or other chemical cleaners before self-cleaning cycle. These can damage the oven lining.

Self-Cleaning Operation

Step-by-step instructions for activating self-cleaning cycle.

Press and hold "CLEAN" button for 3 seconds until indicator light illuminates.
Select cleaning duration: 2 hours for light soil, 3 hours for heavy soil, or 4 hours for baked-on residue.
Press "START" to begin cleaning cycle - oven door will automatically lock.
Cleaning cycle will complete automatically - do not interrupt.
Allow oven to cool completely before opening door (approximately 1-2 hours after cycle ends).

CAUTION! Oven exterior becomes extremely hot during cleaning cycle. Keep children and pets away.

Post-Cleaning Procedures

What to do after the self-cleaning cycle completes.

Cooling period: Wait until oven temperature drops below 200°F before opening door.
Ash removal: Wipe away fine white ash with damp cloth once oven is cool.
Ventilation: Continue ventilating kitchen until any residual odor dissipates.
Rack cleaning: Clean oven racks separately with warm soapy water.
Final wipe: Use clean damp cloth to wipe entire oven interior.

Control Panel Features

Understanding your AccuBake oven controls for self-cleaning.

Primary Controls: CLEAN button, TIME/TEMP dial, START/CANCEL button, LOCK indicator light.

Cleaning Options: Light clean (2 hours), Normal clean (3 hours), Heavy clean (4 hours). Display: Shows remaining cleaning time and temperature. Safety Features: Automatic door lock, over-temperature protection, child safety lock. Indicators: Clean cycle active, door locked, cooling in progress.

Manual Cleaning Options

Alternative cleaning methods for light cleaning or spot cleaning.

Steam Clean: Add water to oven floor, heat to 250°F for 30 minutes, then wipe clean.
Baking Soda Paste: Apply paste to soiled areas, let sit overnight, then scrub and rinse.
Vinegar Solution: Spray equal parts vinegar and water, let sit, then wipe clean.
Oven Glass: Clean with glass cleaner and soft cloth when cool.

Tip: For routine maintenance, wipe spills immediately after oven cools.

Troubleshooting

Problem	Possible Cause	Solution
Clean cycle won't start	Door not closed properly	Ensure door is completely closed and latched
Smoke during cleaning	Excessive food residue	Wipe up major spills before starting cycle
Door won't open after cycle	Oven still too hot	Wait for cooling period to complete
Error code displayed	Malfunction detected	Consult service manual or contact support
Strong odor persists	Inadequate ventilation	Open windows and use exhaust fan
Cleaning incomplete	Cycle interrupted	Repeat cycle with longer duration

Reset: Press and hold START/CANCEL for 10 seconds to reset control panel if needed.

Maintenance Tips

Regular maintenance to keep your oven in optimal condition.

Clean spills promptly after oven cools. Use oven liners for messy cooking. Avoid using aluminum foil on oven bottom. Regularly clean oven racks and accessories. Check door seal for tight closure. Schedule professional inspection annually.

CAUTION! Never line oven bottom with aluminum foil - this can cause overheating and damage.

Specifications

Oven Capacity: 5.0 cubic feet
Self-Clean Temperature: 880°F (471°C)
Cycle Duration: 2, 3, or 4 hours
Power Requirements: 240V, 30A circuit
Energy Consumption: 5.0 kWh per cleaning cycle
Cooling Time: 1-2 hours after cycle completion
Warranty: 1 year parts and labor, 10 years on oven cavity
Safety Standards: UL 858, CSA C22.2

Warranty Information

Whirlpool AccuBake Oven Limited Warranty: 1-year full warranty on parts and labor, 10-year limited warranty on oven cavity against rust-through. Self-cleaning mechanism covered for 5 years. For service, contact authorized Whirlpool service center. Keep original receipt for warranty claims.

For technical support: 1-800-253-1301 or visit www.whirlpool.com